Power UNITS FOR LIFT TABLE one
Basic Description
This power unit is developed solely for the tiny lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has become broadly made use of while in the marketplace of logistic products like minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled through the solenoid valve together with the velocity controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is designed solely for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the velocity controlled from the adjustable needle valve. Once the lift rises to a high positoin, however the power provide is minimize, the lowering motion is managed through the manual override function.
Energy UNITS FOR LIFT TABLE 3
Common Description
This energy unit is created solely for that large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the speed managed by a pressure compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE four
Common Description
This power unit is developed exclusively for the significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve plus the speed controlled by the adjustable needle valve. When the lift rises to a large positoin, but the power provide is reduce, the lowering movement is controlled by the manual override function.
Specific Notes
1. This power unit is of S3 duty cycle, 
which could only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean the many hydraulic components concerned in advance of installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is recommended.
4. Oil altering is needed following the first a hundred operation hrs,afterwards the moment every 3000 hours.
five. The electrical power unit proven is designed to be mounted vertically.
